Quick tip · combitech® system Model construction
User tip no. 70
The square tube, 1 or 2 branches offset, is suitable, for example, to rivet a metal sheet to the offset branch so that the sheet does not protrude from the square tube. This is very useful and sensible depending on the application.
User tip no. 71
With the square edge profile, a model container can be built for example. The container wall profiles can be neatly edged in this case. This means there is no need for riveting or screwing.The square tube, 2 branches inside, is suitable for making spacious shapes. The branches can be used here, for example, as a stop for a thin plywood panel.
User tip no. 72
On the square tube, 2 branches at 180° there is a very wide top surface for screwing and riveting. This enables very stable joints in the model construction area.
User tip no. 73
The square tube, 2 branches, inside is suitable for making spacious shapes. The branches can be used here, for example, as a stop for a thin plywood panel.
User tip no. 74
The U profiles are suitable for framing various wood panels or other model construction profiles.
User tip no. 75
With the hinge profile you can make hinges for various applications, such as for a model dump truck.
User tip no. 76
The one and two-sided covering profile is used, for example, as an underrun protection device on a truck. The one and two-sided support profile combined with the covering profiles is used to frame metal sheets or thin Plexiglas.